Автоматическая система управления транцевыми плитами ACS А. Комплект состоит из модуля управления и панели управления транцевыми плитами в 2-х плоскостях (крен-дифферент).
Панель для второго поста управления (на флайбридж и т.п.) В КОМПЛЕКТ НЕ ВХОДИТ - ПРИОБРЕТАЕТСЯ ОТДЕЛЬНО!!!!
Имеет полностью автоматический и ручной режим управления плитами, функцию "мелкого" шага угла наклона плит и возможность подключения дополнительного пульта управления плитами, например для флайбриджа или внешнего палубного поста управления.
Теперь не нужно постоянно подбирать оптимальный угол наклона плит постоянными переключениями клавиш - процессор и встроенный гироскоп это сделают за Вас. При необходимости Вы всегда сможете взять контроль в свои руки отключив автоматический режим.
Попробуйте симулятор работы системы автоматического выравнивания транцевых плит
ACS A
For all boats
Choose the ACS A if it is easier to connect to the trim tabs in the engine room
Planing and semidisplacement hulls
Shaftdrives, sterndrives, IPS and outboards
Optional flybridge control panel available
Typical boat length: 25 ... 50 feet
Controls roll and pitch
Controls roll (Healing)
Controls pitch (Trim angle)
Trim tabs connected to a separate control unit
The wires of the actuators or hydraulic pump are connected to a control unit that can be located anywhere in the boat
Optional flybridge control panel available
The main panel and the flybridge control panel are connected together at the control unit
Compatible with all popular trim tabs
Electromechanical trim tabs, Lectrotab, Lenco
Hydraulic trim tabs, Bennett, Instatrim
Tab position display
Tab position is estimated and displayed for all kind of trim tabs
Turning detection
Automatic control is suspended while turning
For all sea conditions
The automatic control adapts to varying sea conditions
Off the plane sleep
Auomatic control is suspended while off the plane
Automatic retraction
The trim tabs are retracted to prevent marine growth